incinerator manufacturers

2.1 General Description

The plant has to have four different sections that demonstrate three fundamentals of turbulence, home time and temperature retention. The regulated segments may contain but not Limited to:
M ) The chimney should be visible to the operator in the feeding place.
2. Feed chamber/charging
Capacity/island: 4000 kg/day; 25000 kg/day; 31000 kg/day; 48000 kg/day

Burning temperature — over 12000C

Two chambers — minimal

Emissions — dioxin and heavy metaly — better then Kyoto protocol

Emission — monitoring method

Waste unloiding — directly from squander track to incineration

d) A smoke density meter/recorder should be supplied.
B) Ensure secondary air supply is controlled.
E) A solid particulate meter/recorder should be supplied.
3. Main combustion chamber
4. Particulate scrubbers
O) The purpose for measurement of emissions will be provided.

2.7 Instrumentation

a) Device for discovering the interior wall temperature rather than burner flame temperature has to be provided for both primary and secondary chambers.
C) Ensure residence time isn’t less than two seconds.
D) Opacity of this smoke must not exceed 20% seen from 50 yards with naked eyes.
7. Minimum capacity of main chamber = 0.18 cubic metres
2.6 Chimney/Stack

l) The chimney should have a minimum height of 10 metres above ground level and also clear the highest point of the building by not less than 3 metres to get most roofs. The topography and height of adjoining buildings within 50 metres radius should be taken into consideration.

1. SCOPE OF WORK The work specified in the contract will include.
2.3 Main Combustion Chamber.

a) This chamber should be equipped with burners that use low sulphur gas.
1. Overall plant layout
G) The average dioxin and furan concentration at the emission shouldn’t exceed 80mg/m3 total dioxins and furans if quantified for a period of 6 to 16 hours.

– Manual technical observation is sent with the hardware together with all explanations of failures and resolutions
Supply, Installation and Commissioning of An Incinerator in Eastern Hydros [ Page 28

2.2 Feeding and Fixing
N) The minimum exit rate should be 10 metres per second and at least twice the surrounding wind speed (Efflux speed = end speed x 2) whichever is higher to ensure no down washing of leaving gases.
F) Ensure both primary and secondary combustion temperatures are preserved until all waste is completely combusted. The particulate collectors can contain some of the following or a combination thereof:
Controlled hygienic mechanical feeding that doesn’t negatively influence the air temperature at the main and secondary chambers of this incineration shall be used.
E) All the emission to the air other than steam or water vapour has to be odourless and free of mist, fume and droplets.
6. The stack/chimney.
F) Any other instrument which may be considered necessary.
B) The chamber should ensure a minimal exit temperature of 850 degrees centigrade.

2.4 Secondary Combustion Chamber (After burner)

a) Should be fitted with burners that use low sulphur gas.
8. Burn rate (rate of waste incineration) = at least 20 kg each hour
1.
C) Fabric filters
D) Ensure that the gas temperature measured against the inside wall at the secondary chamber rather than in the fire zone isn’t less than 1100 degrees centigrade.
C) The secondary chamber gas residence time shall be at least 1 second in 1050 +/- 50 degrees centigrade with 3 percent oxygen in the stack gas.
B) The temperature of the primary chamber shall be 800 +/- 50 degrees centigrade
9. Ought to have a full width counterbalance loading door enabling easy access to the main chamber for loading and removing ash.
a) Cyclone separator
3. Assessment and preparation and structure of a standard incineration shed with one waste storage space ( see the layout )

4. Provision of maintenance and operation manuals and drawings complete with care program and directions. Onsite training for maintenance and operation employees.

IMPORTANT
2. Provision for adherence to OSHA along with other statutory requirement concerning Health and Safety of employees during implementation of the functions covered in this tender.
5.
E) Ensure the emitted oxygen content of the emitted gases is less than 11%
B) An audible and visible alarm has to be set up to warn the operator when the secondary chamber temperature falls to below the required temperature.

– Manual technical monitoring is shipped with the hardware with all explanations of failures and resolutions
Capacity/island : 4000 kg/day ; 25000 kg/day ; 31000 kg/day ; 48000 kg/day

Burning temperature – over 12000C

Two chambers – minimum

Emissions – dioxin and heavy metaly – better then Kyoto protocol

Emission – monitoring system

Waste unloiding – directly from waste track to incineration